Setting up your own Router

If you are using your own router with your Compass internet connection, you will need to configure it with the settings below.

 

These will work on most modem/routers as long as the modem is not carrier locked and you have configured it correctly. The settings will also vary depending on the type of connection you have; such as ADSL, VDSL, or UFB.

Fibre

WAN Connection Type: PPPoE / Ethernet WAN

Username: customer@compassnet.co.nz

Password: compass

VLAN Tagging: None/Disabled

IP Version: IPv4 or IPv6

MTU Size: 1492 or 1500

NAT: Enabled

IP Address: Get Automatically

 

ADSL

Username: customer@compassnet.co.nzPassword: compassConnection Type: PPPoAEncapsulation: VC-MUXVPI: 0VCI: 100MTU: 1492 or 1500

IP Address: Get Automatically

 

VDSL

WAN Connection Type: PPPoEUsername: customer@compassnet.co.nzPassword: compassConnection Type: VDSL or VDSL 2Interface: PTM 0VLAN ID: 10MTU: 1492 or 1500

IP Address: Get Automatically

 

These will work on most modem/routers as long as the modem is not carrier locked and you have configured it correctly. The settings will also vary depending on the type of connection you have; such as ADSL, VDSL, or UFB.